Materials Research (Jul 2014)
Micro and nanometric wear evaluation of metal discs used on determination of biodiesel fuel lubricity
Abstract
The contact of diesel fuel with engine subsystems demands a good wear resistance. Lubricity is an important feature for integrity of injection system and the sulphur composites are primarily responsible for lubrication of the injector nozzle. Biodiesel is responsible for partially restoring the lubricity of diesel fuel that presents low levels of sulphur composites and, furthermore, it causes less pollution than diesel fuel. The lubricity is measured through the wear scar diameter following the ASTM D 975 standards. However, the friction and wear with light loads of micro/nanocomponents are highly dependent on surface interactions that can be evaluated by microscopy techniques. This study aimed to measure and to analyze the biodiesel lubricity and their blends (B5, B20) with diesel by observing the wear scars of discs using the scanning electronic microscopy (SEM), atomic force microscopy (AFM) and micro roughness techniques. The fuels performance was evaluated using HFRR tribometer. The tests conditions were based on standard ADTM D-6079-04. The coefficient of friction was measure during the test. After the test, the worn ball and disc were analyzed by SEM, AFM and profilometer. The results showed that the addition of biodiesel in diesel improve the tribological performance of fuel. Also, the just WSD value is not sufficient to evaluate the lubrication ability of a fuel. Analysis of the worn disc surfaces proved to be compatible with WSD number and also more sensitive to these kinds of fuels, showing mainly the form and intensity of the wear.
