Microleakage of different provisionalization techniques for class I inlays

Abstract

Background/purpose: To investigate the effects of different provisionalization methods on the microleakage of class I inlay cavities. Materials and methods: Class I inlay cavities were prepared on human molars (n = 60). Teeth were divided into six groups (n = 10). In the first group (ST-C), Structur 2SC (ST) was used with a provisional luting agent, and in the second group (SY-C), Systemp Inlay (SY) was directly applied and light-polymerized. In the remaining four groups, cavities in the third (SB-ST) and fourth (OS-ST) groups were, respectively, pretreated with the bonding agents, Single Bond (SB) and One Step Plus (OS), and the fifth (SB-SY) and sixth (OS-SY) groups were pretreated with the same bonding agents. The third and fourth groups were then restored with ST and the fifth and sixth groups with SY. The teeth were subjected to thermal cycling and immersed in a 0.5% basic fuchsin solution for 24 hours. Specimens were sectioned and examined for leakage. Data were analyzed using the Kruskal–Wallis and Mann–Whitney U tests (P < 0.01). The interface between the provisional material and dentin was observed using a scanning electron microscope (SEM). Results: Groups treated with a bonding agent (SB-SY and OS-SY) before placement of the light-polymerized provisional material had significantly less microleakage (P < 0.01). No statistical differences were found between leakage scores of the remaining groups. The OS-SY group displayed the best cavity wall-inlay adaptation under SEM. Conclusion: The microleakage in class I inlay cavities could be reduced by the application of dentin-bonding agents after cavity preparation followed by the placement of light-polymerized provisional restorative materials.

Keywords

• inlay
• microleakage
• scanning electron microscope