Additive Manufacturing Through 3D Printing of the Mark HOS Pipe DN 50, Using ABS+ Filament

Abstract

This paper deals with the additive manufacturing by 3D printing of the Hose Pipe DN 50 landmark which is part of the Gas Reduction R2-Hose DN 2 in subassembly. This sub-assembly is a component part of the washing head of the light water well drilling installations FA 100, FA 125, FH 150 and FG 40. The generic name of the washing head will be FA 100. We use 3D printing technology because, on the one hand, it is technically possible to make the part and on the other hand, for economic reasons. It is approximately ten times cheaper to make the part through 3D printing than through conventional technologies.

Keywords

• hose pipe
• 3d printing
• fused deposition modeling
• water drilling installation