Hydrogen–Water Isotope Catalytic Exchange Process Analysis by Simulation

Abstract

The hydrogen–water isotope catalytic exchange process has been widely applied in the tritium-containing water treatment process. It can be compared and analyzed conveniently with process simulation software. In this study, the catalytic exchange process was simulated by Aspen Plus software (V11). According to the simulation results, the main reaction process was that HDO in the liquid phase converts into HD in the gas phase, and the reaction mainly occurred at the bottom of the column, exhibiting a two-orders-of-magnitude-higher reaction amount compared to that observed in the top section. Different side reactions occur at distinct positions along the column, exhibiting a reaction amount that is lower by one to two orders of magnitude compared to the main reaction and aligning in the same direction as the main reaction. The optimum operating temperature is 60~80 °C, with the best performance observed at 70 °C, because of the large reaction equilibrium constant and the suitable ratio of vapor to hydrogen (1:4~1:1.5) in the gas phase. The influence of the residence time was investigated by introducing reaction kinetic equations. The residence time should be more than 1 s to ensure an adequate reaction. The influence of operating conditions on the hydrogen–water isotope catalytic exchange process can be deeply investigated by process simulation, and more mass transfer process quantities can be obtained. It plays a promoting role in guiding the process design and condition optimization.

Keywords

• hydrogen–water exchange
• process simulation
• LPCE column
• hydrogen isotope exchange
• reaction process