Experimental observation of the TJI-initiated HPDI gas combustion: Vertically crossed flame jet and methane jet

Abstract

In the field of natural gas marine engines, the high-pressure direct injection (HPDI) technology is widely used to achieve emission reduction while maintaining equivalent thermal efficiency and power output compared to diesel engines. In these engines, the in-cylinder combustion is primarily initiated by the diesel spray flame near the top dead center (TDC). In the present work, pre-chamber turbulent jet ignition (TJI) is employed to substitute diesel injection to initiate the combustion of HPDI methane jets. The optical experiments of ignition and flame development in the TJI-HPDI system with various injector configurations and injection/ignition control parameters are conducted in a constant-volume combustion chamber (CVCC). It is revealed that with the increase of injection-ignition delay(ti), three ignition modes are observed sequentially: methane jet suppresses ignition, methane jet first suppresses ignition then promotes flame propagation, and direct ignition and promoted flame propagation. The effect of various injection-ignition delays and injection pulse width were explored. The injection-ignition delay significantly influences the combustion characteristics such as heat release rate, while the injection pulse width influences the duration of the lifted jet flame. The flame lift-off length first decreases and then increases due to variations in thermodynamic conditions and oxygen concentration. With a larger-nozzle injector, the critical injection-ignition delay to initiate the main chamber combustion is significantly reduced. Moreover, the use of different nozzle diameters leads to varying levels of turbulent intensity in the methane jet, which in turn affects the combustion behavior.

Keywords

• HPDI
• Methane jet
• Turbulent jet flame
• Pre-chamber