Minerals (Jan 2023)
Study on Key Parameter Design and Adaptability Technology of the 110 Mining Method for the Yuwang NO.1 Coal Mine in the Diandong Mining Area
Abstract
The 110 mining method is a high-efficiency entry-retaining technology without coal pillars or filling materials. At present, there is no precedent for its application in the Huaneng Group. In order to introduce this technology, it is planned to carry out experimental application research in the Yuwang NO.1 Coal Mine of the Huaneng Diandong mining area. The Yuwang NO.1 Coal Mine is a typical coal and gas outburst mine with a coal seam group. In view of the introduction of the 110 mining method under these conditions, first, the geological conditions of the Yuwang NO.1 Coal Mine in the Huaneng Diandong mining area are analyzed, the geological characteristics of the test mining face are summarized, and the practical feasibility of the 110 mining method is analyzed according to the geological characteristics of “one soft, one low, two high, and two complex”. Then, according to the engineering experience, calculations, and analysis, the key parameters of roof cutting of the test mining face in the Yuwang NO.1 Coal Mine are obtained, and with the help of a numerical simulation, the roof-cutting height, the roof-cutting angle, and the blasting parameters are numerically simulated and analyzed. The roof-cutting key parameters of the test face are obtained as follows: the roof-cutting depth is 7 m, the roof-cutting angle is 15°, and the blasting method is continuous hole blasting with 500 mm spacing. After that, according to the coal and gas outburst and the occurrence conditions of coal seams in the Yuwang NO.1 Coal Mine, a variety of gob closure design schemes and gob gas drainage design schemes are put forward, and the field effect investigation scheme is given. After the tunnels and open-off cut of the test coal mine’s first mining face are connected, under the guidance of the above research results, the field blasting test and the 110 mining method entry-retaining test are further carried out to verify the rationality of the design of the roof-cutting parameters and the feasibility of the gangue wall closure and gas drainage design. Furthermore, in the process of the field practice, continuous research is carried out on the stope pressure law and the adjacent layer gas drainage technology under the 110 mining method, and finally, the 110 mining method application technology system in the Diandong Mining Area is formed.
Keywords