Water Supply (Dec 2021)
Dynamic simulation of inner flow in a photovoltaic pump based on Simulink and CFD
Abstract
To study the internal flow characteristics of the photovoltaic pump under the transient change of solar radiation, the simulation algorithm of the photovoltaic pump system was established by MATLAB/Simulink and CFD for the first time and the results were validated by the test. Firstly, the change rule of pump flow rate and rotation speed under transient solar radiation was obtained by Simulink. Then the results of the change rule were transformed into the boundary condition of CFD by CEL function and the transient flow field in the photovoltaic pump was obtained. The internal flow characteristics and pressure pulsation in the pump were analyzed when the solar radiation increases or decreases transiently. The results demonstrate that the numerical calculation can provide accurate prediction for the characteristics of internal flow in the pump. The numerical results are closed to the experimental results, the minimum error of pressure is 0.93% and the maximum error is 1.78%. When the solar radiation increases transiently, the low pressure area at the impeller inlet gets larger obviously and the jet-wake at the impeller outlet becomes more obvious. The pressure pulsation in the impeller gradually increases and becomes stable after 0.6 s. The pressure from the impeller outlet to the guide vane outlet is stable at 123 kPa. When the solar radiation decreases transiently, the pressure in the impeller takes 1.6 s to be stable. Larger pressure pulsation occurs from the impeller outlet to the guide vane inlet and the maximum differential pressure is 10 kPa. Compared with the transient increase of solar radiation, the pressure in the impeller takes over 0.2 s to stabilize when the solar radiation transient decreases. Meanwhile, the results in this paper can provide references for other transient characteristics research. Highlight First, the relation between pump flow rate and rotation speed under transient solar radiation was obtained by Simulink. Then the results from Simulink were transformed to be the boundary condition of CFD by CEL function. The internal flow characteristics and pressure pulsation in the pump were analyzed under the instantaneous increase or decrease of the solar radiation.;
Keywords
