Multimode Design and Piezoelectric Substrate Anisotropy Use to Improve Performance of Acoustic Liquid Sensors

Abstract

Using acoustic wave modes propagation in piezoelectric plates loaded with conductive liquids, peculiarities of the mode-liquid acoustoelectric interaction are studied. It is found that (i) in contrast to bulk and surface acoustic waves propagating in piezoelectric semiconductors, the acoustoelectric attenuation of the modes is not symmetric in respect to its maximum, (ii) a large increase in attenuation may be accompanied by a small decrease in phase velocity and vice versa, (iii) the peculiarities are valid for “pure” (without beam steering) and “not pure” (with beam steering) modes, as well as for modes of different orders and polarizations, and (iv) conductivity of test liquid increases electromagnetic leakage between input and output transducers, affecting results of the measurements. To decrease the leakage, the liquid should be localized between transducers, outside the zone over them. If so, the mode sensitivity may be as large as 8.6 dB/(S/m) for amplitude and 107°/(S/m) for phase. However, because of comparable cross-sensitivity towards viscosity and dielectric permittivity, modes with selective detection of liquid conductivity are not found.

Keywords

• plate acoustic waves
• liquid sensor
• substrate anisotropy
• liquid conductivity