Minimizing thermal damage to vascular nerves while drilling of calcified plaque

Abstract

Abstract Objective Drilling of calcified plaque (DCP) inside the artery is a method for removing calcified plaques. This study investigated the effect of drill. To validate the maximum temperature calculated by computer simulation, this value was also measured by an experimental on a phantom model. Results Increasing drill bit diameter during drilling would increase the temperature in vascular nerves. In a drill bit with a diameter of 4 mm, the risk of thermal necrosis in vascular nerves of the artery wall decreased by 8.57% by changing the drill from WC to NT. The same value for a drill bit with a diameter of 6 mm was 10.17%. However, the trend of the generated temperature in the vascular nerves did not change significantly with change of the material and diameter of the drill bit. The results showed that for DCP with the least risk of thermal necrosis in vascular nerves and subsequently the lowest risk of restenosis, coagulation and thermal stroke of the patient, the best option is to use a drill bit with a diameter of 4 mm and NT material for drilling.

Keywords

• High speed drilling
• Vascular nerve
• Finite element method
• Calcified plaque
• Thermal stroke