EFSA Journal (Oct 2021)

Safety assessment of the process Omorika Recycling, based on PET direct iV+ technology, used to recycle post‐consumer PET into food contact materials

  • EFSA Panel on Food Contact Materials, Enzymes and Processing Aids (CEP),
  • Claude Lambré,
  • José Manuel Barat Baviera,
  • Claudia Bolognesi,
  • Andrew Chesson,
  • Pier Sandro Cocconcelli,
  • Riccardo Crebelli,
  • David Michael Gott,
  • Konrad Grob,
  • Marcel Mengelers,
  • Alicja Mortensen,
  • Gilles Rivière,
  • Inger‐Lise Steffensen,
  • Christina Tlustos,
  • Henk Van Loveren,
  • Laurence Vernis,
  • Holger Zorn,
  • Vincent Dudler,
  • Maria Rosaria Milana,
  • Constantine Papaspyrides,
  • Maria de Fátima Tavares Poças,
  • Alexandros Lioupis,
  • Evgenia Lampi

DOI
https://doi.org/10.2903/j.efsa.2021.6872
Journal volume & issue
Vol. 19, no. 10
pp. n/a – n/a

Abstract

Read online

Abstract The EFSA Panel on Food Contact Materials, Enzymes and Processing Aids (CEP) assessed the safety of the recycling process Omorika Recycling (EU register number RECYC224), which uses the Starlinger PET direct iV+ technology. The input is hot caustic washed and dried poly(ethylene terephthalate) (PET) flakes mainly originating from collected post‐consumer PET containers, with no more than 5% PET from non‐food consumer applications. The flakes are extruded to pellets, which are then crystallised, preheated and treated in a solid‐state polycondensation (SSP) reactor. Having examined the challenge test provided, the Panel concluded that the three steps, extrusion, crystallisation and SSP are critical in determining the decontamination efficiency of the process. The operating parameters to control the performance of these critical steps are temperature, gas flow, pressure and residence time. The challenge test demonstrated that this recycling process is able to ensure that the level of migration of potential unknown contaminants into food is below the conservatively modelled migration of 0.1 μg/kg food. Therefore, the Panel concluded that the recycled PET obtained from this process is not of safety concern, when used at up to 100% for the manufacture of materials and articles for contact with all types of foodstuffs for long‐term storage at room temperature, with or without hotfill. The final articles made of this recycled PET are not intended to be used in microwave and conventional ovens and such uses are not covered by this evaluation.

Keywords